Mazda 3 Owners Manual: Fastening the Seat Belt
PCM Inspection [Mzr 2.0, Mzr 2.5]
Using M-MDS NOTE: PIDs for the following parts are not available on this model. Go to the appropriate part inspection page. CMP sensor Main relay 1. Connect the M-MDS to the DLC-2. 2. Switch the ignition to ON. 3. Measure the PID value. ...
Quarter Window Glass Removal
1. Remove the following parts: a. Rear seat cushion. b. Rear scuff plate. c. Tire house trim. d. Trunk side upper trim. e. C-pillar trim. 2. Apply protective tape along the edge of the body and the quarter window glass. NOTE: For the areas of the sealant that are difficult ...
Vanity Mirror Illumination Bulb Removal/Installation
1. Disconnect the negative battery cable.. 2. Insert a tape-wrapped fastener remover into the service hole, and pry it in the direction indicated by the arrow to remove the lens. 3. Remove the vanity mirror illumination bulb. 4. Install in the reverse order of removal.