Mazda 3 Owners Manual: Specifications

Mazda 3 Owners Manual: Specifications

Engine

Mazda 3. Engine


Electrical System

Mazda 3. Electrical System


*1 Q-85 is designed for i-ELOOP system. Only Q-85 should be used to ensure correct operation of i-ELOOP system. Consult an Authorized Mazda Dealer for details.

*2 Not for i-ELOOP system.

*3 This spark plug provides the SKYACTIV-G engine with optimum performance. Contact an Authorized Mazda Dealer for details.

CAUTION When cleaning the iridium plugs, do not use a wire brush. The fi ne particulate coating on the iridium alloy and platinum tips could be damaged.

Lubricant Quality

Mazda 3. Lubricant Quality


NOTE Refer to Introduction on for owner's responsibility in protecting your investment.

Capacities

(Approximate Quantities)

Mazda 3. Capacities


Check oil and fluid levels with dipsticks or reservoir gauges.

*1 Check the vehicle identification number on the vehicle identification number plate. Refer to Vehicle Identification Number on .

Dimensions

4-Door

(U.S.A. and Canada)

Mazda 3. Dimensions


(Mexico)

Mazda 3. Dimensions


5-Door

(U.S.A. and Canada)

Mazda 3. 5-Door


(Mexico)

Mazda 3. 5-Door


*1 The overall height is categorized according to the antenna type as follows:

Type A

Mazda 3. 5-Door


Type B

Except above.

Weights

U.S.A. and Canada

SKYACTIV-G 2.0

Mazda 3. Weights


SKYACTIV-G 2.5

Mazda 3. Weights


Mexico

SKYACTIV-G 2.0

Mazda 3. Weights


SKYACTIV-G 2.5

Mazda 3. Weights


Air Conditioner

The type of refrigerant used is indicated on a label attached to the inside of the engine compartment. Check the label before recharging the refrigerant. Refer to Climate Control System on .

Mazda 3. Air Conditioner


Light Bulbs

Exterior light

Mazda 3. Light Bulbs


*1 UNECE stands for United Nations Economic Commission for Europe.

*2 LED is the abbreviation for Light Emitting Diode.

Interior light

Mazda 3. Interior light


*1 UNECE stands for United Nations Economic Commission for Europe.

Tires

NOTE The tires have been optimally matched with the chassis of your vehicle.

When replacing tires, Mazda recommends that you replace tires of the same type originally fitted to your vehicle. For details, contact an Authorized Mazda Dealer.

Check the tire pressure label for tire size and inflation pressure.

Refer to Tire Inflation Pressure on .

After adjusting the tire pressure, initialization of the tire pressure monitoring system is necessary to make the system operates normally.

Refer to Tire Pressure Monitoring System Initialization on .

Standard tire

(U.S.A. and Canada)

Mazda 3. Standard tire


(Mexico)

Mazda 3. Standard tire


1 person's weight: About 75 kg

Temporary spare tire

Mazda 3. Temporary spare tire


Lug nut tightening torque

When installing a tire, tighten the lug nut to the following torque.

108—147 N•m (12—14 kgf•m, 80—108 ft•lbf)

Fuses

Refer to Fuses on

Identification Numbers
Vehicle Identification Number The vehicle identification number legally identifies your vehicle. The number is on a plate attached to the cowl panel located on the left corner of the dashboard. Th ...
Personalization Features
The following personalization features can be set or changed by an Authorized Mazda Dealer. Consult an Authorized Mazda Dealer for details. Additionally, some of the personalization features can ...
Other materials:

Hood Removal/Installation
WARNING: Removing the hood without supporting it could cause the hood to fall and cause serious injury. Always perform the procedure with at least another person to prevent the hood from falling. 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Fro ...

Drive Belt Auto Tensioner Inspection [Skyactiv G 2.0]
WARNING: A hot engine can cause severe burns. Turn off the engine and wait until it is cool before servicing. CAUTION: If the rubber part of the drive belt auto tensioner is damaged by a screwdriver or other tool, oil in the hydraulic pressure unit could leak and the tens ...

Spark Plug Inspection [Mzr 2.3 Disi Turbo]
Specification Spark plug type L3BD-18110, L3YD-18110 Plug Gap Inspection CAUTION: To avoid possible damage to the tip, do not adjust the plug gap. To prevent damaging the tip, use a wire type plug gap gauge when inspecting the plug gap. 1.

Related news

  • Mazda 3 Service Manual: Front Door RemovalInstallation
  • Chevrolet Cruze Repair Manual: Rear Window Defogger Description and Operation
  • Subaru Legacy: Brake assist system
  • Nissan Maxima: Installing front license plate
  • Nissan Sentra Service Manual: 6MT: RS6F94R

  • Mazda 3 Owners Manual: Specifications

    Mazda 3 Owners Manual: Specifications

    Mazda 3 Owners Manual: Specifications

    Mazda 3 Owners Manual: Specifications

    Mazda 3 Owners Manual: Specifications

    Mazda 3 Owners Manual: Specifications

    Mazda 3 Owners Manual: Specifications

    Mazda 3 Owners Manual: Specifications

    Mazda 3 Owners Manual: Specifications

    Mazda 3 Owners Manual: Specifications

    Mazda 3 Owners Manual: Specifications

    Mazda 3 Owners Manual: Specifications

    Mazda 3 Owners Manual: Specifications

    Mazda 3 Owners Manual: Specifications

    Mazda 3 Owners Manual: Specifications

    Mazda 3 Owners Manual: Specifications

    Mazda 3 Owners Manual: Specifications

    Mazda 3 Owners Manual: Specifications

    Mazda 3 Owners Manual: Specifications

    Mazda 3 Owners Manual: Specifications

    Mazda 3 Owners Manual: Specifications