Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

Mazda 3 Service Manual: Generator Removal/Installation [Mzr 2.0, Mzr 2.5]

WARNING:

  • Remove and install all parts when the engine is cold, otherwise they can cause severe burns or serious injury.

  • When the battery cables are connected, touching the vehicle body with generator terminal B will generate sparks. This can cause personal injury, fire, and damage to the electrical components. Always disconnect the negative battery cable before performing the following operation.

CAUTION:

  • The generator can be damaged by the heat from the exhaust manifold. Make sure the generator duct is installed securely (MZR 2.5).

1. Remove the battery cover..

2. Disconnect the negative battery cable..

3. Remove the aerodynamic under cover No.2 and splash shield as a single unit..

4. Remove the generator drive belt with the A/C drive belt still installed and set it out of the way. (MZR 2.0).

5. Remove the drive belt. (MZR 2.5).

6. Remove in the order indicated in the table.

7. Install in the reverse order of removal.

MZR 2.0


1

Terminal B cable

2

Generator connector

3

Generator

(See Generator Installation Note (MZR 2.0).)


MZR 2.5


1

Generator duct

(See Generator Duct Removal Note (MZR 2.5).)

(See Generator Duct Installation Note (MZR 2.5).)

2

Generator duct bracket

3

Terminal B cable

4

Generator connector

5

Generator

(See Generator Removal Note (MZR 2.5).)

(See Generator Installation Note (MZR 2.5).)


Generator Installation Note (MZR 2.0)

1. Align the generator fixing hole with the engine side hole, then temporarily tighten the generator installation bolts in the order of A, B, C, and D.

2. Securely tighten the generator installation bolts in the order of A, B, C, and D.

Generator Duct Removal Note (MZR 2.5)

1. Remove the generator duct from above the engine compartment.

Generator Removal Note (MZR 2.5)

1. Set the cooler pipe out of the way..


2. Remove the generator from above the engine compartment.


Generator Installation Note (MZR 2.5)

1. Tighten bolt A temporarily.

2. Tighten bolt B, C to the specified tightening torque.

3. Tighten bolt A to the specified tightening torque.

Generator Duct Installation Note (MZR 2.5)

1. Install the generator duct to the generator duct bracket and tighten nuts temporarily.

2. Tighten nuts to the specified tightening torque.

Refrigerant Charging
CAUTION: Do not exceed the specification when charging the system with refrigerant. Doing so will decrease the efficiency of the air conditioner or damage the refrigeration cycle parts. ...
Other materials:

Neutral Switch Removal/Installation [G66 M R]
1. Remove the battery cover.. 2. Disconnect the negative battery cable. 3. Remove the battery component. (ex: battery, battery tray and PCM component). 4. Remove the aerodynamic under cover No.2.. 5. Drain the oil from the transaxle.. 6. Remove the neutral switch. 7. Install the neu ...

Parking Brake
CAUTION Driving with the parking brake on will cause excessive wear of the brake parts. NOTE For parking in snow, refer to Winter Driving regarding parking brake use. Setting the parking brake Depress the brake pedal and then firmly pull the parking brake lever fully upwar ...

Check Valve Inspection [Skyactiv G 2.0]
Airflow Inspection 1. Remove the vacuum hose.. 2. Blow air into the vacuum hose using your mouth from the vacuum pump side and verify that the air flows to the intake manifold side, then blow air from the intake manifold side and verify that the air does not flow to the vacuum pump side.

Related news

  • Mazda 3 Service Manual: Power Window Subswitch RemovalInstallation
  • Hyundai Elantra: Changing tires
  • Hyundai Elantra: CDP, AUX(PA710S)
  • Kia Soul: CVVT System Mode
  • Toyota Sienna 2010-2018 Owners Manual: Opening the fuel tank cap

  • Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5

    Mazda 3 Service Manual: Generator RemovalInstallation Mzr 2.0, Mzr 2.5