Mazda 3 Service Manual: Knee Bolster Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Driver-side front scuff plate.
b. Driver-side front side trim.
c. Hood release lever.
d. Upper panel.
e. Shift knob (MTX).
f. Selector lever knob (ATX).
g. Shift panel.
h. Side wall.
j. Driver-side lower panel.
3. Remove the bolts.
4. Remove the knee bolster.
5. Install in the reverse order of removal.
Intermediate Sensor Inspection [FS5 A EL]
On-Vehicle Inspection 1. Inspect the power supply circuit for the intermediate sensor. a. Set the battery component (ex: battery, battery tray and PCM component) out of the way. b. Disconnect the intermediate sensor connector. c. Switch the ignition to ON (engine off). d. Measure the ...
Sunroof Unit Removal/Installation
CAUTION: If the sunshade is forced close while the sunroof is open, the sunshade could be damaged. 1. Disconnect the negative battery cable.. 2. Remove the rain sensor cover. (Vehicles with auto light/wiper system). 3. Disconnect the rain sensor connector. (Vehicles with auto l ...
Hazard Warning Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the center panel.. 3. Verify that the continuity between the hazard switch terminals is as indicated in the table. If not as indicated in the table, replace the hazard warning switch. 4.