Nissan Sentra Owners Manual: Manual control

Nissan Sentra Owners Manual: Manual control

Nissan Sentra Owners Manual: Manual control

While using the voice recognition system, it is possible to select menu options by using the steering wheel controls instead of speaking voice commands. This can be especially helpful if the noise of driving makes it difficult for the voice recognition system to accurately interpret commands.

The manual control mode does not allow dialing a phone number by digits. The user may select an entry from the Phonebook or Recent Calls lists. To re-activate voice recognition, exit the manual control mode by pressing and holding the PHONE/END (time,) button. At that
time, pressing the PHONE/SEND (will) button
will start the Hands Free Phone System.

Operating tips

  • To enter manual control mode, start the voice recognition system and tilt the tuning (system will) switch up or down. The
    system will speak Showing Manual Options when manual controls are initially activated.
  • To browse the menu options, tilt the tuning (system will) switch up or down. The
    system will always speak the current menu option. Depending on the audio display, it will also show the current menu option.
  • To select the current menu option, press the PHONE/SEND (To go back to the previous menu, press the) button.

  • To go back to the previous menu, press the PHONE/END (current) button. If the
    current menu is the Main Menu, pressing the PHONE/END (the) button will exit
    the Phone system.
  • To exit the manual control mode, press and hold the PHONE/END (for) button
    for 5 seconds
Voice Adaptation (VA) mode
Voice Adaptation allows up to two out-of-dialect users to train the system to improve recognition accuracy. By repeating a number of commands, the users can create a voice model of their own voice ...
Troubleshooting guide
The system should respond correctly to all voice commands without difficulty. If problems are encountered, try the following solutions. Where the solutions are listed by number, try each solutio ...
Other materials:

Ignition signal
Component Function Check 1.INSPECTION START Turn ignition switch OFF. Start engine. Does the engine start? YES >> GO TO 2. NO >> Proceed to EC-456, "Diagnosis Procedure". 2.IGNITION SIGNAL FUNCTION With CONSULT Perform “POWER BALANCE” in “ACT ...

Rear-facing child restraint installation using the seat belts
WARNINGThe three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being properly secured.

Related news

  • Mazda 3 Service Manual: Engine RemovalInstallation Mzr 2.3 Disi Turbo
  • Kia Optima: Headlight Aiming Adjustment
  • Chevrolet Cruze Repair Manual: Front Compartment Side Rail Sectioning (Long, MAG-Welding)
  • Garage door opener programming in the U.S.A
  • Nissan Rogue Service Manual: Shift lock system

  • Nissan Sentra Owners Manual: Manual control

    Nissan Sentra Owners Manual: Manual control

    Nissan Sentra Owners Manual: Manual control

    Nissan Sentra Owners Manual: Manual control

    Nissan Sentra Owners Manual: Manual control

    Nissan Sentra Owners Manual: Manual control

    Nissan Sentra Owners Manual: Manual control

    Nissan Sentra Owners Manual: Manual control

    Nissan Sentra Owners Manual: Manual control

    Nissan Sentra Owners Manual: Manual control

    Nissan Sentra Owners Manual: Manual control

    Nissan Sentra Owners Manual: Manual control

    Nissan Sentra Owners Manual: Manual control

    Nissan Sentra Owners Manual: Manual control

    Nissan Sentra Owners Manual: Manual control

    Nissan Sentra Owners Manual: Manual control

    Nissan Sentra Owners Manual: Manual control

    Nissan Sentra Owners Manual: Manual control

    Nissan Sentra Owners Manual: Manual control

    Nissan Sentra Owners Manual: Manual control

    Nissan Sentra Owners Manual: Manual control

    Nissan Sentra Owners Manual: Manual control