Toyota Sienna Service Manual: Bluetooth Module Initialization Failed
DTC 57-47 Bluetooth Module Initialization Failed
DTC Detection Condition
||Radio and navigation assembly|
HINT: After the inspection is completed, clear the DTCs.
1 REPLACE RADIO AND NAVIGATION ASSEMBLY
Gyro ErrorDTC 58-10 Gyro Error DTC 80-10 Gyro Error DESCRIPTION DTC No. DTC Detection Condition Trouble Area 58-10 Ground short, power supply short, or open circuit in th ...
Diagnostic trouble code chart
If a malfunction code is displayed during the DTC check, check the circuit listed for that code in the table below. (Proceed to the page given for that circuit.) POWER BACK DOOR SYSTEM DTC No. Detection Item Trouble Area B2222 PBD Pulse Sensor Malfuncti ...
Radio Receiver Power Source Circuit
DESCRIPTION This circuit provides power to the radio receiver. WIRING DIAGRAM INSPECTION PROCEDURE 1 INSPECT RADIO RECEIVER ASSEMBLY Disconnect the radio receiver connector. Measure the resistance according to the value in the table below. Standard resistance Measure t ...
1. INSTALL BRAKE ACTUATOR NOTICE: Do not remove the hole plugs before connecting the brake tubes. New actuators are filled with brake fluid. (a) Install the brake actuator assembly with the 2 nuts. Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 2.