Toyota Sienna Service Manual: Installation
1. Install thermostat
(a) Install a new gasket to the thermostat.
(b) Install the thermostat with the jiggle valve facing up.
Hint: the jiggle valve may be set within 10° on either side of the prescribed position.
2. INSTALL WATER INLET
(a) Install the water inlet with the 2 nuts .
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
3. INSTALL NO. 2 IDLER PULLEY SUB-ASSEMBLY
(a) Install the idler pulley cover plate and idler pulley sub-assembly with the bolt.
Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf)
4. CONNECT NO. 2 RADIATOR HOSE
(a) Connect the No. 2 radiator hose to the engine.
5. INSTALL V-RIBBED BELT (See page EM-7) 6. INSTALL FRONT FENDER APRON SEAL RH 7. INSTALL FRONT WHEEL RH 8. ADD ENGINE COOLANT (See page CO-7) 9. INSTALL NO. 1 ENGINE UNDER COVER (See page EM-63) 10. INSPECT FOR COOLANT LEAK (See page CO-1) 11. INSTALL V-BANK COVER SUB-ASSEMBLY (See page EM-63)
Inspection1. INSPECT THERMOSTAT (a) Inspect the thermostat. HINT: The valve opening temperature is inscribed on the thermostat. (b) Immerse the thermostat in water and gradually heat the water. ...
Cooling fan motorOn-vehicle inspection 1. No. 1 Cooling fan motor (A) check that the motor turns smoothly when the battery is connected to the fan motor connector. (B) measure the current while the motor is ...
Rear side sunshades
Rear door window Rear quarter window Pull the tab up. Secure the sunshade using the hooks. To retract the sunshade, pull the tab up slightly to unhook the sunshade, and lower the sunshade slowly. NOTICE To ensure normal operation of the rear sunshades, observe ...
1. INSTALL RACK & PINION POWER STEERING GEAR ASSEMBLY (a) Install the power steering gear assembly with the 2 bolts and nuts. Torque: 70 N*m (714 kgf*cm, 52 ft.*lbf) 2.