Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

Insufficient Coolant Temperature for Closed Loop Fuel Control

DESCRIPTION

Refer to DTC P0115 (See page ES-133).

Insufficient Coolant Temperature for Closed Loop Fuel Control

MONITOR DESCRIPTION

The resistance of the ECT sensor varies in proportion to the actual ECT. The ECM supplies a constant voltage to the sensor and monitors the signal output voltage of the sensor. The signal voltage output varies according to the changing resistance of the sensor. After the engine is started, the ECT is monitored through this signal. If the ECT sensor indicates that the engine is not yet warm enough for closed-loop fuel control, despite a specified period of time having elapsed since the engine was started, the ECM interprets this as a malfunction in the sensor or cooling system and sets the DTC.

Example: The ECT is 0°C (32°F) at engine start. After 5 minutes running time, the ECT sensor still indicates that the engine is not warm enough to begin closed-loop fuel (air-fuel ratio feedback) control. The ECM interprets this as a malfunction in the sensor or cooling system and sets the DTC.

MONITOR STRATEGY

MONITOR STRATEGY

TYPICAL ENABLING CONDITIONS

TYPICAL ENABLING CONDITIONS

TYPICAL MALFUNCTION THRESHOLDS

TYPICAL MALFUNCTION THRESHOLDS

WIRING DIAGRAM

Refer to DTC P0115 (See page ES-134).

INSPECTION PROCEDURE

HINT

  • If any of DTCs P0115, P0116, P0117 or P0118 are set simultaneously with DTC P0125, the Engine Coolant Temperature (ECT) sensor may have an open or a short circuit. Troubleshoot those DTCs first.
  • Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air-fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

1 CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0125)

(a) Connect the intelligent tester to the DLC3.

(b) Turn the ignition switch to the ON position.

(c) Turn the tester on.

(d) Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.

(e) Read the DTCs.

Result

HINT:

If any DTCs other than P0125 are output, troubleshoot those DTCs first.

2 INSPECT THERMOSTAT

(a) Remove the thermostat (See page CO-16).

(b) Check the valve opening temperature of the thermostat (See page CO-17).

Standard: 80 to 84°C (176 to 183°F)

HINT:

In addition to the above check, confirm that the valve is completely closed when the temperature is below the standard.

(c) Reinstall the thermostat (See page CO-17).

3 CHECK COOLING SYSTEM

(a) Check for defects in the cooling system that might cause the system to be too cold, such as abnormal radiator fan operation or any modifications.

REPLACE ENGINE COOLANT TEMPERATURE SENSOR (See page ES-516)

Other materials:

On-vehicle inspection
1. CONNECT INTELLIGENT TESTER (a) Connect the intelligent tester to the DLC3. (b) Start the engine and run at idle. (c) Select the ACTIVE TEST mode on the intelligent tester. HINT: Please refer to the intelligent tester operator's manual for further details. 2.

Related news

  • Nissan Rogue Service Manual: Rear spoiler
  • Hyundai Elantra: Battery. Description and Operation
  • Hyundai Elantra: Tire replacement
  • Subaru Legacy: Compass zone adjustment
  • Mazda 3 Service Manual: Climate Control Unit Inspection Full Auto Air Conditioner

  • Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control

    Toyota Sienna Service Manual: Insufficient Coolant Temperature for Closed Loop Fuel Control