Toyota Sienna Service Manual: Perform signal check
When entering signal check mode, the tire pressure warning ECU sets all the signal check DTCs first.
After completing signal check for each inspection item, the DTCs for systems that are determined to be normal by the tire pressure warning ECU will be erased.
The DTCs for other inspection items may not be erased when only a certain signal is inspected.
- When signal check returns to normal mode, all the signal check DTCs will be erased.
(a) Make sure that the ignition switch is off.
(b) Connect the intelligent tester to DLC3.
(c) Turn the ignition switch to the ON position.
(d) Select the SIGNAL CHECK on the intelligent tester.
HINT: Every time the test mode DTC clear conditions are satisfied, the tire pressure warning light comes on for 1 second. Then, the tire pressure warning light blinks at 0.125-second intervals.
(e) Drive the vehicle at 12 mph (20 km/h) or more for 10 seconds or more to check the vehicle speed signal (C2191/91).
(f) Loosen the valve core and rapidly reduce the pressure (at least 40 kPa (0.41 kg/cm2, 5.8 psi) within 30 seconds or more) to check the transmitter data (C2181/81 to C2184/84).
HINT: The transmitter ID can be transmitted by rapidly reducing the tire pressure.
(g) Check that the tire pressure warning system test mode DTCs are erased.
(h) Check the tire pressure warning reset switch.
(1) Press the tire pressure warning reset switch.
(2) Check the tire pressure warning indicator light.
HINT: After the signal check is completed, check for a signal check DTC to confirm the system status
(j) End of SIGNAL CHECK
After completing the test mode (SIGNAL CHECK), turn the ignition switch off and disconnect the tester.
DTC of SIGNAL CHECK (TEST DIAGNOSIS) function: If a trouble code is displayed during the test mode DTC check, check the circuit listed for that code. For details of each code, refer to the relevant page listed under respective "DTC No." in the chart.
Enter test modeHINT: Operation of the tire pressure warning reset switch can be checked in TEST MODE. During TEST MODE, the system is not initialized by pushing the tire pressure warning reset switch. The ...
Problem symptoms tableHINT: Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column ...
Capacity and distribution
Cargo capacity depends on the total weight of the occupants. (Cargo capacity) = (Total load capacity) - (Total weight of occupants) Steps for Determining Correct Load Limit Locate the statement “The combined weight of occupants and cargo should never exceed XXX kg or XXX lbs.” on your ...
Items to initialize The following items must be initialized for normal system operation after such cases as the battery being reconnected, or maintenance being performed on the vehicle. Item When to initialize Power sliding door (if equipped) After reconnecting o ...
Power Source Circuit
DESCRIPTION Power is supplied to the fold seat control ECU through the L-RR2 SEAT and R-RR2 SEAT fuses. WIRING DIAGRAM INSPECTION PROCEDURE 1 INSPECT FUSE (L-RR2 SEAT, R-RR2 SEAT) Remove the fuses from the R/B No.