Toyota Sienna Service Manual: System Voltage

Toyota Sienna Service Manual: System Voltage

System Voltage

MONITOR DESCRIPTION

The battery supplies electricity to the ECM even when the ignition switch is off. This power allows the ECM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, these memories are cleared and the ECM determines that there is a malfunction in the power supply circuit. When the engine is next started, the ECM illuminates the MIL and sets the DTC.

System Voltage

HINT:

If DTC P0560 is set, the ECM does not store other DTCs.

MONITOR STRATEGY

MONITOR STRATEGY

TYPICAL ENABLING CONDITIONS

TYPICAL ENABLING CONDITIONS

TYPICAL MALFUNCTION THRESHOLDS

TYPICAL MALFUNCTION THRESHOLDS

WIRING DIAGRAM

WIRING DIAGRAM

INSPECTION PROCEDURE

HINT:

Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air-fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

1 CHECK FUSE (EFI NO. 1 FUSE)

CHECK FUSE (EFI NO. 1 FUSE)

(a) Remove the EFI No. 1 fuse from the engine room junction block.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance: Below 1 Ω

(c) Reinstall the EFI No. 1 fuse.

2 INSPECT ECM (BATT VOLTAGE)

INSPECT ECM (BATT VOLTAGE)

(a) Measure the voltage according to the value(s) in the table below.

Standard voltage

REPLACE ECM (See page ES-498)

3 CHECK HARNESS AND CONNECTOR (ECM - EFI NO. 1 FUSE)

CHECK HARNESS AND CONNECTOR (ECM - EFI NO. 1 FUSE)

(a) Check the harness and the connector between the EFI No. 1 fuse and ECM.

(1) Remove the EFI No. 1 fuse from the engine room junction block.

(2) Disconnect the E4 ECM connector.

(3) Measure the resistance according to the value(s) in the table below.

Standard resistance :

(4) Reconnect the ECM connector.

(5) Reinstall the EFI No. 1 fuse.

4 CHECK HARNESS AND CONNECTOR (EFI NO. 1 FUSE - BATTERY)

CHECK HARNESS AND CONNECTOR (EFI NO. 1 FUSE - BATTERY)

(a) Check the harness and the connector between the EFI No. 1 fuse and battery.

(1) Remove the EFI No. 1 fuse from the engine room junction block.

(2) Disconnect the negative battery cable.

(3) Measure the resistance according to the value(s) in the table below.

Standard resistance:

(4) Reconnect the negative battery cable.

(5) Reinstall the EFI No. 1 fuse

5 INSPECT BATTERY

(a) Check that the battery is not depleted.

CHECK AND REPLACE ENGINE ROOM RELAY BLOCK

Other materials:

SPD Signal Error
DTC 58-43 SPD Signal Error DTC 80-43 SPD Signal Error DESCRIPTION DTC No. DTC Detection Condition Trouble Area 58-43 A difference between the GPS speed and SPD pulse is detected. Speed signal circuit Radio and navigation assembly ...

Installation
1. INSTALL AIR CONDITIONING BLOWER ASSEMBLY (a) Install the air conditioning blower assembly with the 3 bolts. Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) NOTICE: Tighten the bolts in the order shown in the illustration to install the air conditioning blower assembly. 2.

Related news

  • Toyota Highlander Owners Manual: Preparations to usewirelesscommunication
  • Kia Sorento: Panorama Sunroof Adjustment
  • Toyota Tacoma 2015-2018 Service Manual: CD Sound Skips
  • Chevrolet Cruze Owners Manual: Remote Keyless Entry (RKE) System Operation
  • Toyota Sienna 2010-2018 Owners Manual: Rear ceiling lights

  • Toyota Sienna Service Manual: System Voltage

    Toyota Sienna Service Manual: System Voltage

    Toyota Sienna Service Manual: System Voltage

    Toyota Sienna Service Manual: System Voltage

    Toyota Sienna Service Manual: System Voltage

    Toyota Sienna Service Manual: System Voltage

    Toyota Sienna Service Manual: System Voltage

    Toyota Sienna Service Manual: System Voltage

    Toyota Sienna Service Manual: System Voltage

    Toyota Sienna Service Manual: System Voltage

    Toyota Sienna Service Manual: System Voltage

    Toyota Sienna Service Manual: System Voltage

    Toyota Sienna Service Manual: System Voltage

    Toyota Sienna Service Manual: System Voltage

    Toyota Sienna Service Manual: System Voltage

    Toyota Sienna Service Manual: System Voltage

    Toyota Sienna Service Manual: System Voltage

    Toyota Sienna Service Manual: System Voltage

    Toyota Sienna Service Manual: System Voltage

    Toyota Sienna Service Manual: System Voltage

    Toyota Sienna Service Manual: System Voltage